Hiya.
I creating my own PicoZed 7z015 carrier card with a PCIe edge connector. I'm following the PicoZed Carrier Card V2 schematics and most of the board fab details I've found are in this document:
http://zedboard.org/sites/default/files/documentations/PZCC_FMC2_Rev1_Layout_160321.PDF
One of the things I've noticed on the PCIe female connector side is that the card connector is supposed to have a 20 degree bevel on its edges:
https://cdn.amphenol-icc.com/media/wysiwyg/files/drawing/10142333.pdf
I see that the physical PicoZed Carrier Card V2 as well.
I'm using Altium, is there any special way to designate this bevel in the layout or fab documents?
Thanks!
