Dear all,
I'm using the Picozed 7030 + FMC Carrier Card V2.
I need to transfer data from the DDR3 to my laptop (Matlab). For real-time application, I need a data rate >5.3 Mbps so I cannot use the UART. I was thinking to use the USB PS. However, I cannot really understand how to use this peripheral. As far as I understood, I need to use the OTG controller.
Should I use USB0 or USB1?
Is there any example sending data out the USB-A connector (integrated on the Picozed/Zedboard) through the OTG controller?
Thank you in advance.
Best Regards,
Marco