UART application

Dear all,
I'm new to Microzed and I need to use UART communication for my project. I need to get data using the UART and I cannot found any tutorial that helps me to set the UART. I already found example from Xilinx but it is not working. Any idea where I can get the tutorial to setting the UART?

Parents

0 Former Member over 11 years ago

So if I understand correctly you are using a MicroZed board and have added an axi_uartlite core to your Zynq Programmable Logic (PL) section and connected it via an axi_interconnect core to the Zynq processor, and connected the interrupt from the axi_uartlite core to a Zynq PS interrupt that you have enabled. How have you connected the uartlite rx and tx signals to your external device? The Pmod port on the MicroZed is only connected to Zynq MIO pins and so cannot provide a connection from PL based peripherals. Are you using a carrier card?

If you have built this hardware and exported to SDK I would first verify that it works in non-interrupt mode.

Once these steps verify your hardware design we can start to debug interrupt based operation.

-Gary
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 11 years ago in reply to Former Member

solved, thx anyway
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 9 years ago in reply to Former Member

Greetings,
I am facing the same problem. I cannot see whether the buffer sends information or not. Would you please share the way you solved it? Please, a lot of people would thank you.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Former Member over 9 years ago in reply to Former Member

Greetings,
I am facing the same problem. I cannot see whether the buffer sends information or not. Would you please share the way you solved it? Please, a lot of people would thank you.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data