Actions
Forum Thread Details
  • State Not Answered
  • Replies 5 replies
  • Subscribers 355 subscribers
  • Views 1012 views
  • Users 0 members are here
Related

UltraZed EG not booting

xlmnsp

I am having some problems getting my UltraZed EG starter kit to boot. 

I've followed all of the quick start steps and inserted the supplied SD card. The fan is working.

 

After turning on the board, D10 on the carried board lights up and D15 on the carried board stays dark.

 

D4 on the SOM flashes and if the boot mode is set to SD, D3 on the SOM lights up continously. If the boot mode is set to one of the QSPI modes the SOM stays dark after the D4 flash. Except in some cases if I leave the board on for a while, D3 turns on.

 

Nothing shows up on the serial connection.

 

I hope this description helps with identifying the problem. I would greatly appreciate any help.

Parents
  • 0

    I had the same issues - until firm (not excessive) pressure was applied - though rather firm pressure was required.  Fully seated the top of the SOM is flush with the top of the jumper on JP1.  

    I jumpered JP1 per the Getting Started instrutions provided with the kit (received ~7/24/18).  Boot from QSPI gave me garbled output on the serial console (@115200 baud), but booting from SD with the latest out of box image downloaded from zedboard.org booted linux as expected.

Reply
  • 0

    I had the same issues - until firm (not excessive) pressure was applied - though rather firm pressure was required.  Fully seated the top of the SOM is flush with the top of the jumper on JP1.  

    I jumpered JP1 per the Getting Started instrutions provided with the kit (received ~7/24/18).  Boot from QSPI gave me garbled output on the serial console (@115200 baud), but booting from SD with the latest out of box image downloaded from zedboard.org booted linux as expected.

Children
No Data