Hardware Co Simulation with Vivado System Generator and Zedboard

Hello Guys

I'm having a problem with Hardware co simulation, my simulink model works just fine and i managed to generate the hwcosim block but when i replace it, i don't get the results that i need i always get Zeros in my outputs. i'm using vivado 2015.2 and matlab 2015a, i checked my license and it's good. i'm really lost and i don't know what to do ! please i need your help.

Thank you

0 mbrown over 9 years ago

Hello Padma,
Unfortunately Sysgen questions are outside of the scope of this forum, though the zedboard community is rather large and you may get a response from the community. However, I would suggest searching the Xilinx forums first, then posting your question there.
Thanks,
Matt
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 9 years ago in reply to mbrown

Hey mbrown,
i've already posted in Xilinx forum, tried some solutions but none of them worked for me.
Thank for replying
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel