I2C communication on zedboard

I am new to the zedboard (zynq 702) ... I want to use I2C for the same . Please provide me detailed steps for the I2C communication. Please help me ..

Parents

0 jafoste4 over 9 years ago

Hi Dipti,
If you are looking for some IIC examples you could check out the examples that are located within your sdk, for instance this is located in my 2016.2 Vivado SDK at
C:\Xilinx\SDK\2016.2\data\embeddedsw\XilinxProcessorIPLib\drivers\iic_v3_2\examples
C:\Xilinx\SDK\2016.2\data\embeddedsw\XilinxProcessorIPLib\drivers\iicps_v3_2\examples
Also here is some excellent information on IIC from NXP Semiconductor that I would reccommend going through.
http://www.nxp.com/documents/user_manual/UM10204.pdf
Since you are new to Zedboard I would also suggest you run through our ZynqHW and Zynq SW labs, they are very beneficial introductory labs.
They are located at :
http://zedboard.com/course/developing-zynq%C2%AE-7000-all-programmable-soc-software-vivado-20133-and-201441
http://zedboard.com/course/developing-zynq%C2%AE-7000-all-programmable-soc-hardware-vivado-20133-and-201441
--Josh
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 9 years ago in reply to jafoste4

Dear Evearyone,
I am new to the zedboard and having trouble on interfacing the gps sensor into the zedboard by using Pmod i2c connection. Does anyone in this forum can give me some working examples or process flow on how to do it. Thanks you very and God bless.

regards,
Glenn
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Former Member over 9 years ago in reply to jafoste4

Dear Evearyone,
I am new to the zedboard and having trouble on interfacing the gps sensor into the zedboard by using Pmod i2c connection. Does anyone in this forum can give me some working examples or process flow on how to do it. Thanks you very and God bless.

regards,
Glenn
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data