Repair Zedboard

Hi,

I contacted you to check if you accept to repair the zedboard FPGAs. From past 1 year and 6 months onwards I am working on zedboard, but this week when I turned on the power supply of the zed board and I didn't do any wrong operations, its not getting turning on, the green LED is not turning on( power status).

I will wait for your answer. Also I have a similar issue with my previous board.

Thank you so much.

regards

Top Replies

dyessgg over 2 years ago +2

What debugging steps have you done so far? 1. Is the outlet your power supply plugged into been tested and verified working? 2. Is the AC power cord plugged firmly into the power supply? 3. Have…

Parents

bidrohini over 2 years ago

These solutions may help: support.xilinx.com/.../zedboard-is-not-turning-on
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
DDina over 2 years ago in reply to bidrohini

Hi, thank you for your answer

I saw this post before. So for this reason I want to know I want to know if there is any possibility to back the zedboards to repair I think it's matter of regulators (reprogrammed or replaced).

Thank you so much
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

DDina over 2 years ago in reply to bidrohini

Hi, thank you for your answer

I saw this post before. So for this reason I want to know I want to know if there is any possibility to back the zedboards to repair I think it's matter of regulators (reprogrammed or replaced).

Thank you so much
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data