This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Circuit Studio Producing Custom Stencil

Hi There,

Can we produce custom stencil in circuit studio with relief shapes etc?

When I unchecked embedded apertures (RS274X) option, circuitstudio remove all component pads from gerbers. What are the steps to produce our own stencil (paste file) on circuit studio.

cheers!

Thilanga

shabaz over 1 year ago

Hi,

This might be possible, but I don't know for sure. Have you asked at the Altium forum for CircuitStudio by following the information here, which directs you to a link:

Announcement: CircuitStudio will no longer be sold by Farnell. It is available direct from Altium.
Cancel
Vote Up 0 Vote Down

Cancel
Thilanga over 1 year ago in reply to shabaz

Thank you very much for the reply, I will post the question there also
Cancel
Vote Up 0 Vote Down

Cancel