This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

EDIF Netlist

I have a Flat schematic. EDIF out put only shows up when a schematic is selected. When I generate the EDIF it only generates the netlist for that 1 schematic. Is there a configurator to netlist all the schematics?

e14softwareteam over 8 years ago

Checking with the developers.

e14 Software Team
Cancel
Vote Up 0 Vote Down

Cancel
e14softwareteam over 8 years ago

Here is the response from the developers:

Rather than using the button on the Outputs tab, use the following method.

Open any schematic in the project and click in the search bar at the top right of the screen and type netlist click:

Netlist for Project >EDIF for PCB and this will create an EDF file with the same name as the schematic but it will actually be for the whole project.
Cancel
Vote Up 0 Vote Down

Cancel
fuubar67 over 8 years ago in reply to e14softwareteam

Worked like a charm. Much appreciated.
Cancel
Vote Up 0 Vote Down

Cancel