This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Output generation

Hello, I use Circuit studio 1.4.

When I generate output, the BOM is alway generated as .xls file but it is sometimes generated within the output pdf file, sometimes not. I did not succeed in tracking what it depends on.

I export also PCB 3D print, but I would like to export it from both Above and Below but in PCB 3D Print Settings I can choose only one of them.

Is there any way how to control this?

Thank you.

Parents

e14softwareuk over 7 years ago

As Thomas said the output job file is a simplified version on that available in Designer. However it should be possible to edit the file manually to add in extras but that will mean you won't have full control from the GUI. Obviously any editing it at your own risk but in the distant past I believed I managed to add in an extra output manually.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

e14softwareuk over 7 years ago

As Thomas said the output job file is a simplified version on that available in Designer. However it should be possible to edit the file manually to add in extras but that will mean you won't have full control from the GUI. Obviously any editing it at your own risk but in the distant past I believed I managed to add in an extra output manually.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data