High temperature potting material wanted

Hi out there.

I have been looking quite a while for a high-temperature potting material that can stand 260 deg. C operating. It must have a relatively high mechanical strength (also at 260 deg. C) and a temperature coefficient preferrably below 50 ppm/deg. K.

I have been loking at quite a few epoxies but their TC becomes normally quite high above Tg - and for very high temperature epoxies Tg seems to be quite low (125 deg. C or lower).

Regards

Morten Hammer

Senior Engineer (EE)

Dantec Dynamics A/S

Denmark

0 awinning over 16 years ago

Hi Morten,

I've passed this message on to our technical support team. In the meantime, I don't know if http://www.aremco.com/PDFs/A4.pdf these products would be suitable to your application.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 awinning over 16 years ago in reply to awinning

Hi again,

I've just heard back from out technical support team. They recommend the potting material in the attachment.

Please let me know if this meets your needs

Attachments:
3085_RTVS49 (2).pdf
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel