PCB Peer Review?

If interested i need some help reviewing my design. I havent done any PCB work before and was looking for some review help before i order it.

The layout is attached the power net is 22mm and the Ground is 20mm. The signal will come in through a DB25 and exit on a DB25 power is supplied from an Acopian 28EB5E250 (because i have 28Vdc handy) .

IC:

http://www.deiaz.com/data-sheets/DS-MW-01026-02-D.pdf

Newark P/N's:

796949-4796949-4 Socket Adapter

85K7801 Terminal Board

69K7219 Header

89F3212 Cap

66C6057 Cap

Thanks for the help.

Attachments:

Parents

enrico.migchels over 16 years ago

Hi Paul,

I did some calculations and figured out that the dimensions are in mils. That's ok. Always stay above 10 mils trace width, otherwise your board supplier will have difficulties making that board (will add cost). In general your design should be ok, but reconsider the capacitors. If you make only 1 board you might consider soldering the capacitors on the adapter socket directly, but this could also be done afterwards if the decoupling causes problems.

Good luck.

Best regards,

Enrico Migchels
Power Conversion Design Engineer
Heliox B.V.
Best - The Netherlands
www.heliox.nl
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Former Member over 16 years ago in reply to enrico.migchels

Thanks for all the help everyone. It is greatly appreciated.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Former Member over 16 years ago in reply to enrico.migchels

Thanks for all the help everyone. It is greatly appreciated.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data