Actions
Forum Thread Details
  • State Not Answered
  • Replies 7 replies
  • Subscribers 302 subscribers
  • Views 1029 views
  • Users 0 members are here
Related
See a helpful answer?

Be sure to click 'more' and select 'suggest as answer'!

If you're the thread creator, be sure to click 'more' then 'Verify as Answer'!

Need Help Identifying and Finding a Specific Componet

Former Member

I have a bad LED 3 digit display and i have not been able to find one with the proper terminals to replace it with. The issue is all the ones i have found dont have the gap on the five pin side. Here is the info I have.

 

Over all display: 13.5mm X 22mm X 6mm (tall)

Digits: 7mm X 4mm

Pins: .5mm

Pin spacing (from pin center to pin center): 2.5mm

Display color: Red

 

On the side it says:

A303E-CL G/W

S0826 04 RoHS P

 

The display and digit size can fluctuate a little but the pins need to be the same as its for a pre-manufactured board.

 

If it maters its out of an Autometer Pro-Comp Ultra-Lite wideband air/fuel gauge.

Attachments:
image
image
Parents
  • 0

    Got it fixed. I tried to get in touch with AOP but they never responded to me. Ended up getting a LTD-M2806RI from mouser. I then used ribbon cable strands to route the board holes to the right Display terminals. Tucks the wires away and put it back in the housing and works like a champ. Hope this helps someone out in the future. If need be i can provide a schematic and step by step of how I did it.

    Thanks for a the help.

Reply
  • 0

    Got it fixed. I tried to get in touch with AOP but they never responded to me. Ended up getting a LTD-M2806RI from mouser. I then used ribbon cable strands to route the board holes to the right Display terminals. Tucks the wires away and put it back in the housing and works like a champ. Hope this helps someone out in the future. If need be i can provide a schematic and step by step of how I did it.

    Thanks for a the help.

Children
  • 0 in reply to Former Member

    Jack,

     

    I am going to suspect that you have an AutoMeter A/F gauge.   I have the exact same problem  In fact, I have it times 2!   I bought the first gauge and it worked great for about 1 year then I started loosing segments.   The gauge as you know are about $400.  Well I was using this in a show car so I bit the bullet and bought another one.   Well it lasted just about the same length of time and it started doing the same thing but different segments.   So I feel your pain.  Gauge functions properly and the secondary LEDs are working fine so I agree with you on the statement that the functionality is working.  It also matches the readings on my diagnostic tools.

     

    Now with that said, I am also looking to change the readouts.   I would very much like to see your diagrams or any information that you have regarding how you did this.

     

    Thanks so much...

    Victor

    victor@myfoose.com