One thing to try is to pick a resistor that doesn't look too bad, polish its leads with a pen eraser, clip one of them and measure it. Then you can infer the coding scheme. This wont hurt anything because you are going to replace them anyway.
One thing to try is to pick a resistor that doesn't look too bad, polish its leads with a pen eraser, clip one of them and measure it. Then you can infer the coding scheme. This wont hurt anything because you are going to replace them anyway.
Yes they all measure the same even the very bad looking ones @ 2.2k but where did U get the 1.2 from, they all look the same to me? And do U stick with 1/2w? The new ones will be smaller then the old one will they not?
