Need Help On LCD Inverter Board

I am making a RaspBerry PiTop, and i am using an old HP Pavilion Zv6000 for the case. The CFL inverter board has a 7 pin input plug and i have never seen one before. I scoured the internet for a pinout so i can wire it but i have not found one. Would a regular 6 pin inverter board work? Mine is similar to the picture below but it is a Delta DAC-08B017. I have found nothing on the part.

Top Replies

shabaz over 10 years ago +1

If it isn't possible to decipher the pinout (since sometimes [but not always] it is possible by inspecting the tracks, the part number of the IC on the board and a multimeter and some experimentation)…

0 shabaz over 10 years ago

If it isn't possible to decipher the pinout (since sometimes [but not always] it is possible by inspecting the tracks, the part number of the IC on the board and a multimeter and some experimentation) then yes it can be replaced with another one, it is non-critical. As long as the replacement has a single output connector too, and a transformer of approximately similar physical size, it will work - perhaps not optimally, but will light up fine.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 10 years ago in reply to shabaz

Ok thanks, . If it doesnt work ill just buy a new screen that fits the case
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel