Actions
Forum Thread Details
  • State Not Answered
  • Replies 3 replies
  • Subscribers 304 subscribers
  • Views 1394 views
  • Users 0 members are here
Related
See a helpful answer?

Be sure to click 'more' and select 'suggest as answer'!

If you're the thread creator, be sure to click 'more' then 'Verify as Answer'!

MP720019 and LabView

MikaelLindgren

Before purchasing the oscilloscope I would like to verify which LabView drivers are available. I cannot find anything in the supplied software.

Parents
  • 0

    Thanks for the tip on Owon Oscilloscopes. I did find a later version of the Programming Guide there. However, in the PG are listed only two Trigger Types: Edge and Video. In the osc data sheet are listed Edge, Pulse, Video, and Slope. I specifically need to use the Pulse width trigger, so I need to make sure it is programatically accessible from NI-VISA and LabView. Can anyone verify this? Since it is not listed in the PG it is not likely to work...

Reply
  • 0

    Thanks for the tip on Owon Oscilloscopes. I did find a later version of the Programming Guide there. However, in the PG are listed only two Trigger Types: Edge and Video. In the osc data sheet are listed Edge, Pulse, Video, and Slope. I specifically need to use the Pulse width trigger, so I need to make sure it is programatically accessible from NI-VISA and LabView. Can anyone verify this? Since it is not listed in the PG it is not likely to work...

Children
No Data