Chattering effect

Hi,

I have build a circuit to drive the solenoid valve and a small DC water pump both operates at 12 volts dc.

Before I connect these 2 loads to the circuit the working of relay and is perfectly working fine, but as soon as I connect these 2 loads relay is getting chattered.

Circuit and relay is operating at 5volts DC and load is 12 volts.

Top Replies

Fred27 over 2 years ago +1

I'm a little confused where you're getting the 5V from, but generally inductive loads (relays, motors) can cause quite large negative spikes on their power supply. I suspect this may have something to…

Parents

0 Fred27 over 2 years ago

I'm a little confused where you're getting the 5V from, but generally inductive loads (relays, motors) can cause quite large negative spikes on their power supply. I suspect this may have something to do with your problem.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Fred27 over 2 years ago

I'm a little confused where you're getting the 5V from, but generally inductive loads (relays, motors) can cause quite large negative spikes on their power supply. I suspect this may have something to do with your problem.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data