I'm trying to develop an arm board, and the footprints for the ic's i want to use are all on the libraries.
Happens that i want to have the footprints i want to use into a single library, and then i'd like to assign the pins
as they figure in each datasheet. I had read the whole manual for eaglecad 6.10 and i don't understand how should i
use it. My goal is to "declare" the ic's and then insert then in the circuit, so i can "autoroute" it and after some tweaks
have the pcb traces. Beg your pardon if this sounds too basic but it's the first time i use an app like Eagle.
