DAPLink is not working -#2

27 Apr 2020

It is the last day for this weekend, and i am rushing to try to able to use Modus toolbox

i find there are lots of video tutorial provided by Cypress Semiconductor on both Modus Toolbox [1] and PSoC 101 and there my starting point is.

however, i don't seem to see any example on its LCD support.

the nearest is emwin, that can be used in MBED

i also look at https://iotexpert.com/2019/12/09/ which does have a displaythread that update to TFT screen

i also look at https://www.cypress.com/file/504396/download , but sadly it doesn't seem to be suitable in fact i not quite sure where to use it.

Experiment Step

MBED can use online an offline IDE. A good documentation is here https://os.mbed.com/teams/Cypress/

i am tyring with the PSoC 6 WiFi-BT Pioneer Kit, hence i go further to https://os.mbed.com/platforms/CY8CKIT-062-WiFi-BT/

to take note:

Previously i have know MBED via it online IDE, that has a similarity to Arduino IDE

after reading the documentation above, i decide to download the offline IDE, available via https://os.mbed.com/studio/

As of to date, i get version 0.9.1

i find that i can't transition to DAPLink following the guide mode upon connect to PC, so i need follow the instruction "NOTE: if you cannot transition to DAPLink mode using CY8CPROTO-062-4343W, then get Firmware-loader 2.2.01 or newer, which fixes that problem." on https://github.com/cypresssemiconductorco/Firmware-loader

however, even after i update the firmware i still face problem. It is similar to what's discussed on forum https://community.cypress.com/thread/48874?start=0&tstart=0

References

Top Comments

Parents

Comment

Children