How to Off the conductor on the both sides of Via

Hi,

I am working on RF design. I want to off the conductor on the top and bottom side of the PCB. Because in my board front side i have antenna. If i put the via then, the via consuctor short to atenna.

In many of RF designs (PCB Boards) all the via are off. Means the connectivity will be there from top to bottom layer. But the conductor (Copper) is not visivle on the board. It will look like a small point not like via.

So , please help me to resolve the issue.

Regards,

Reddy

Parents

clem57 over 8 years ago

Take a look at https://www.maximintegrated.com/en/app-notes/index.mvp/id/5100 and the other tutorials. You did not mention your frequencies. In general, Critical guidelines for RF and microwave PCB Design | Embedded gives some general highlights.
Clem
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
clem57 over 8 years ago in reply to clem57

Try http://www.analog.com/media/en/training-seminars/design-handbooks/Basic-Linear-Design/Chapter12.pdf
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Former Member over 8 years ago in reply to clem57

Both URLs are handy but for electronic newbies like me, the https://www.maximintegrated.com/en/design/techdocs/tutorials/index.mvp sub-site has excellent tutorials.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Former Member over 8 years ago in reply to clem57

Both URLs are handy but for electronic newbies like me, the https://www.maximintegrated.com/en/design/techdocs/tutorials/index.mvp sub-site has excellent tutorials.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data