Path to Programmable 3

Forum I am getting this error. Can anyone please help me in solving it ?

Path to Programmable 3 requires membership for participation - click to join

Actions

Forum Thread Details

Replies 8 replies
Subscribers 117 subscribers
Views 1002 views
Users 0 members are here

Related

I am getting this error. Can anyone please help me in solving it ?

manojroy123 over 1 year ago

Top Replies

bidrohini over 1 year ago +2

Here is a thread about this error message: support.xilinx.com/.../could-not-find-arm-device-on-the-board-for-connection-local-zynq-ultrascale-mpsoc-zcu102
flyingbean over 1 year ago +2

Why did you use zcu106/platfomr.spr for Ultra96 board? Ultra96 is not zcu106 FPGA.
manojroy123 over 1 year ago +2

This problem solved by loading custom platform that was build using Vivado ,changing the BSP setting and powering on the board by pressing switch SW4 .

Parents

saadtiwana_int over 1 year ago

This means Vitis cannot detect your board (via JTAG path).

Make sure:

- The board is connected via the USB-to-JTAG

- The board is powered up

- The mode on your board is set to boot from JTAG

It helps to know what board you're using? Is it the Ultra96-v2 or minized?
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel
manojroy123 over 1 year ago in reply to saadtiwana_int

I am using Ulra96-v2. The board is powered on. JTAG pod is tested using serial COM terminal application and it is working properly. I am still getting the error. the boot mode is set to JTAG.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel

Reply

manojroy123 over 1 year ago in reply to saadtiwana_int

I am using Ulra96-v2. The board is powered on. JTAG pod is tested using serial COM terminal application and it is working properly. I am still getting the error. the boot mode is set to JTAG.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel

Children

No Data