the usb to JTAG/UART pod is not able to read UART port using puTTY terminal. Not able to figure out what is going on.
can anyone help me in solving this problem. the board I am using is Ultra96-v2
the usb to JTAG/UART pod is not able to read UART port using puTTY terminal. Not able to figure out what is going on.
can anyone help me in solving this problem. the board I am using is Ultra96-v2
Please make sure your baud rate is set correctly, also worth setting the flow control to None.
Please make sure your baud rate is set correctly, also worth setting the flow control to None.