The software part of this project is already there, so it's time to think about the physical part.
As I said, the goal of this project is to build a mechanism that can show the object being 3D-printed from every sides.
I have a delta printer, which has three legs. So I am going to create three supports a wheel will lean on. Each support will feature a toy car's wheel to reduce the friction and make the movement as smooth as possible.
This is the support with the toy car's wheel
The part is stuck on the leg as shown in picture below
The wheel the camera will be mounted on is made of eight sections as shown in picture. The wheel has been split in eight split because of the limited size of my printer. Sections has then been joined by means of hot glue
The wheel will move on the toy car's wheel
Inside the wheel, is visible the conductive tape that will bring the power supply to the wireless camera
