Actions
Forum Thread Details
  • Replies 8 replies
  • Subscribers 33 subscribers
  • Views 654 views
  • Users 0 members are here
Related

Raspberry Pi Portable Display.

ksharp117

Hello all.

 

I was wondering where/how Ben connected the display to the Raspberry Pi. I've been trying to figure it out by watching the video but can't quiet figure it out.

 

Also, would I be able to connect a display to the B+ the same way.

 

Thanks all.

Parents

  • It was a car back up camera attached directly to the board via the place where the yellow jack used to be. I would use a multimeter to test which pins on the pi connect to which pins a the end of the cable at the monitor, resolder the jcak and attach the points back together, if possible using shielded wiring to minimise interference. Tat connected was wired to the place where the yellow jack was in order to allow him to disconnect the screen if required. The HDMI port is just there for an external monitor. This should also work for a b+

Reply

  • It was a car back up camera attached directly to the board via the place where the yellow jack used to be. I would use a multimeter to test which pins on the pi connect to which pins a the end of the cable at the monitor, resolder the jcak and attach the points back together, if possible using shielded wiring to minimise interference. Tat connected was wired to the place where the yellow jack was in order to allow him to disconnect the screen if required. The HDMI port is just there for an external monitor. This should also work for a b+

Children
No Data