Raspberry Pi Portable Display.

Hello all.

I was wondering where/how Ben connected the display to the Raspberry Pi. I've been trying to figure it out by watching the video but can't quiet figure it out.

Also, would I be able to connect a display to the B+ the same way.

Thanks all.

Parents

royston02 over 11 years ago

Once you get a backup screen, don't hack it. All you have to do is attach yhe yellow wire to the yellow jack on the RPi using a male to male RCA cable. Then you should atach the barrel connecter to a power source. Remember, the outer par is ground and inner/centre pin is positine. The white can be left alone. Then, You would eb better off hacking it.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
kidiccurus over 11 years ago in reply to royston02

If he is going to make a portable then hacking the screen is essential to reduce the size. For desktop use a full monitor is better.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

kidiccurus over 11 years ago in reply to royston02

If he is going to make a portable then hacking the screen is essential to reduce the size. For desktop use a full monitor is better.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

royston02 over 11 years ago in reply to kidiccurus

First test to work, then hack!
Please read last part
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
kidiccurus over 11 years ago in reply to royston02

Sorry, my bad. Yes please test, then hack. I should have read it more thoroughly. Also, positive not positine.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel