Actions
Forum Thread Details
  • Replies 10 replies
  • Subscribers 12 subscribers
  • Views 1922 views
  • Users 0 members are here
Related

Problems getting started or is it dead?? <SOLVED>

phoenixcomm

I got my BB AI about a week ago I had problems getting the fan mounted. But when I plug it in via USBA &gt; USBC type 3 cable but all I get is this. Is my BB dead?

Thanks

Cris H.

 

problem was thas the motherboard didn't do it. I bought a wall rat from 5-blow and now it boots!

NOW how to change the static addresses image

Parents

  • The lights by the ethernet port should start blinking.

     

    First things I'd check:

    • Amp rating of your power supply (2.5 or greater)
    • Unplug the fan and see if it boots
    • Try it with an SD card image and without the SD installed.
  • in reply to Sean_Miller

      wrote:

     

    The lights by the Ethernet port should start blinking.

     

    First things I'd check:

    • Amp rating of your power supply (2.5 or greater)
    • Unplug the fan and see if it boots
    • Try it with an SD card image and without the SD installed.

    I went to the Beagle bone  site and downloaded a fresh image. Then I booted with no problems. Then go into the browser (Chrome) and entered 192.168.7.2 to get Cloud 9. It takes several minutes to get to that point. BTW, you should get at least 2.5 AMP supply. The official Raspberry Pi 4 adaptor from MicroCenter works great!

Reply
  • in reply to Sean_Miller

      wrote:

     

    The lights by the Ethernet port should start blinking.

     

    First things I'd check:

    • Amp rating of your power supply (2.5 or greater)
    • Unplug the fan and see if it boots
    • Try it with an SD card image and without the SD installed.

    I went to the Beagle bone  site and downloaded a fresh image. Then I booted with no problems. Then go into the browser (Chrome) and entered 192.168.7.2 to get Cloud 9. It takes several minutes to get to that point. BTW, you should get at least 2.5 AMP supply. The official Raspberry Pi 4 adaptor from MicroCenter works great!

Children
No Data