Hi,
It's been a while since I last logged in and not even sure if I've ever posted on here before.
So hi, my name is Graeme and I'm an engineer (fast approaching retirement age) residing on the south coast of the UK.
I've been using the above since the beginning of 2023 without any issues. But on Friday I noticed that the DCI function (60mA range) "appeared" to lock up after a 2 or 3 minutes whilst doing a trend graph. I tried a few obvious front panel buttons, but it appeared to have locked up completely and only a power cycle would recover it. Then it would functioned for an hour with no problem. This morning it did it again whilst just on the DCI display and again, after a power cycle it's been OK for nearly an hour now.
Correction: as I was constructing this post it's done it again after c1hr.
Just wondering if anyone else has seen anything like this. I certainly never have since I've had it. It's just being used as a stand alone instrument with no other connections other than power and the measurement connections.
Regards
Graeme
