Actions
Forum Thread Details
  • State Not Answered
  • Replies 4 replies
  • Subscribers 367 subscribers
  • Views 529 views
  • Users 0 members are here
Related

Done LED not on

Former Member

Hello,

recently, I got my zedboards, and I powered it, but both boards DONE led does not show up after 15 seconds.

the Power Good LED is lit on.

When I connect the Platform Cable USB II to the JTAG Port, I get an error Message in iMPACT, that two unknown devices are found, requiring an BSDL file for them.

When I hook up the micro-usb cable to PROG (J17), the Drivers are installed successfully, but Impact complaines about "Error:Impact:2246 A reference voltage has not been detected ..."

Did I get two defect boards?

Parents
  • 0

    I tried to connect with an older iMPACT Software.
    I can connect to the JTAG Port now.

    And I got the Linux to boot up correctly. But I had to read the README file on the sd-card to set the jumper correctly. This readme file should be part of the getting started guide and you shold add a note to the zedboard enclosed print "Getting Started Instructions": Please set the jumper according to README file on sd-card.

Reply
  • 0

    I tried to connect with an older iMPACT Software.
    I can connect to the JTAG Port now.

    And I got the Linux to boot up correctly. But I had to read the README file on the sd-card to set the jumper correctly. This readme file should be part of the getting started guide and you shold add a note to the zedboard enclosed print "Getting Started Instructions": Please set the jumper according to README file on sd-card.

Children