I just received my MicroZed and I am following the Quick Start instructions that were included. http://www.zedboard.org/sites/default/files/documentations/QSC-Z7MB-7Z010-G-v1d_0.pdf.
I followed steps 1-3 and then waited for the blue D2 Done LED to illuminate and it never did. I also tried pressing the RST button and nothing changed. The jumpers are set for QSPI boot mode and the Power Good LED is illuminated. The D3 User LED is also illuminated. Is that supposed to be on? I'm not receiving anything off the UART port either.
Is my board defective? Any advice is appreciated.
Thanks,
Raul
