Beginner, need help understanding the breakout carrier board

Hi, I have recently got into the Microzed due to a project at school, and I am quite lost.

I have experience with Verilog using the Nexys4 FPGA board, and that seem much simpler than the Microzed.

I was able to run a Hello World program through the SDK to the Microzed, and now I wish to use the Breakout Carrier Board for the programmable logics,but I don't understand how to access the Carrier Board, and I was not able to find any instructions or tutorial online about it.

If anyone can send me in the right directions, I would be grateful.

Parents

0 jafoste4 over 7 years ago

Hello,
The carrier board just sends all the extra IO out so it accessible to you. You can then solder on whatever circuit you want to your carrier card to perform you desired application. It does none of the programmable logic.
All the programmable logic is done by the zynq device on the MicroZed.
--Josh
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 jafoste4 over 7 years ago

Hello,
The carrier board just sends all the extra IO out so it accessible to you. You can then solder on whatever circuit you want to your carrier card to perform you desired application. It does none of the programmable logic.
All the programmable logic is done by the zynq device on the MicroZed.
--Josh
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data