Z7030 Getting Started problem

Hi,
I have the following behaviour with my Z7030
D1 green (ok)
D19 green (ok)
D14 green (ok)

D6 off (not ok)
D21 off (not of)

PC user leds 1,2 red
PG user led red

Nay ideas what's going wrong?

regards
Kai

Parents

0 bhfletcher over 9 years ago

That is not much information. Is this out of the box? Is it plugged into a PicoZed FMC Carrier? Are you booting from QSPI, SD Card, or JTAG? What are you doing?

If this is out of the box, have you already read this?
http://zedboard.org/content/done-led-fails-light-picozed-7015-and-7030-out-box

Bryan
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 9 years ago in reply to bhfletcher

Hi Bryan,
it`s plugged into a PicoZed FMC Carrier and I'am booting from QSPI. What I don't understand are the red LEDs and why I don't have a USB connection (no amber LED).

Kai
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Former Member over 9 years ago in reply to bhfletcher

Hi Bryan,
it`s plugged into a PicoZed FMC Carrier and I'am booting from QSPI. What I don't understand are the red LEDs and why I don't have a USB connection (no amber LED).

Kai
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 bhfletcher over 9 years ago in reply to Former Member

The only time the USB-UART Link LED lights is when you actually have a link, meaning the cable has to be plugged into J6 and the PC, the driver installed on the PC, and a utility (like TeraTerm) running that is connected to the link.

The PS and PL user LEDs will turn on, even when not driven, depending on how the unused I/Os and pre-configuration pull-up settings are set. As soon as you put these into your design and control them, then they will turn on and off at your choosing.

Bryan
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel