Actions
Forum Thread Details
  • State Not Answered
  • Replies 3 replies
  • Subscribers 354 subscribers
  • Views 728 views
  • Users 0 members are here
Related

Ultrazed EG PCIe Carrier Card definition files

ramuzed

Hi,

I am attempting to build the U-boot to run on the UltraZed-EG PCIe Carrier card with the UltraZed EG SOM. I have downloaded the
latest snapshot of U-boot from the Git repo.   Searching through the configs directory, I do not see a defconfig file for your board. Could anyone
please tell me where I can find the correct defconfig file to use?  I believe one must exist or there is a compatible defconfig file to use because I
have been able to run  the prebuilt U-BOOT that is part of the AES-ZU3EGES-1-SOM-G-OOB-Release-RC3_0 package.

Parents
  • 0

    Hi Karthick,

     

    The u-boot defconfig is specified in the PetaLinux project config file (<project folder>/project-spec/configs/config):

     

    #

    # u-boot Configuration

    #

    CONFIG_SUBSYSTEM_UBOOT_CONFIG_PETALINUX=y

    # CONFIG_SUBSYSTEM_UBOOT_CONFIG_OTHER is not set

    CONFIG_SUBSYSTEM_UBOOT_CONFIG_TARGET="xilinx_zynqmp_zcu102_rev1_0_defconfig"

    CONFIG_SUBSYSTEM_NETBOOT_OFFSET=0x10000000

    CONFIG_SUBSYSTEM_U__BOOT_TFTPSERVER_IP="AUTO"

     

    The Ultrazed SOM is similar enough to the ZCU102 board that it can use the same u-boot defconfig.  You can either hand edit this file or run 'petalinux-config' from the PetaLinux project folder.

     

    I hope this helps.

     

    --Tom

Reply
  • 0

    Hi Karthick,

     

    The u-boot defconfig is specified in the PetaLinux project config file (<project folder>/project-spec/configs/config):

     

    #

    # u-boot Configuration

    #

    CONFIG_SUBSYSTEM_UBOOT_CONFIG_PETALINUX=y

    # CONFIG_SUBSYSTEM_UBOOT_CONFIG_OTHER is not set

    CONFIG_SUBSYSTEM_UBOOT_CONFIG_TARGET="xilinx_zynqmp_zcu102_rev1_0_defconfig"

    CONFIG_SUBSYSTEM_NETBOOT_OFFSET=0x10000000

    CONFIG_SUBSYSTEM_U__BOOT_TFTPSERVER_IP="AUTO"

     

    The Ultrazed SOM is similar enough to the ZCU102 board that it can use the same u-boot defconfig.  You can either hand edit this file or run 'petalinux-config' from the PetaLinux project folder.

     

    I hope this helps.

     

    --Tom

Children
No Data