2nd Ethernet int to connect PS and PL vai GMII

I redirected Ethernet 1 to PL according to this article http://zedboard.org/content/redirecting-peripherals-mio-emio

But I suppose it is not enough. It's necessary to modify Linux device tree and
1. add definition of the Ethernet 1 (it's simple)
2. tell Ethernet controller to get Rx/Tx clocks from EMIO - I do not have any idea how to do it.

Can you help with it?

Parents

0 Former Member over 11 years ago

Xilinx provides references how to use define clock sources in Device tree. But my knowledge is not enough to add necessary definitions.
https://github.com/Xilinx/linux-xlnx/blob/m...k/zynq-7000.txt
https://github.com/Xilinx/linux-xlnx/blob/m...fixed-clock.txt
https://github.com/Xilinx/linux-xlnx/blob/m...ck-bindings.txt

Much appreciate some help.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 11 years ago in reply to Former Member

The links in your post did not work for me so I am not sure what your references are.

But you should not need to define your GMII clock source in the device tree. If your IP is emulating the PHY interface to the Ethernet MAC GMII interface your IP just needs to provide the clock source that a PHY would normally provide.

-Gary
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Former Member over 11 years ago in reply to Former Member

The links in your post did not work for me so I am not sure what your references are.

But you should not need to define your GMII clock source in the device tree. If your IP is emulating the PHY interface to the Ethernet MAC GMII interface your IP just needs to provide the clock source that a PHY would normally provide.

-Gary
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data