Actions
Forum Thread Details
  • State Not Answered
  • Replies 2 replies
  • Subscribers 73 subscribers
  • Views 277 views
  • Users 0 members are here
Related

Exploding capacitor with Hall Effect sensor

ZeroSizeObject
Hello,
I am using a Hamlin 55100-3H-02-A hall effect sensorHamlin 55100-3H-02-A hall effect sensor as a contactless limit on a machine. When I trigger the sensor, using a magnet, I get a messy output. At the end of the pulse I get a spike in voltage (8-9V). I want to remove this surge and resonating after the pulse. I want a clean signal.
 
I know what you are thinking, read the datasheet on it. I did, and it said to add a capacitor across the + and - leads. However, it did not elaborate on what size. I put in a 500uF cap, and it exploded.
 
image
Pic of the pop at the end.
 
Help!
 
Zero
Parents
  • 0

    What is the sensor connected to ? From your scope trace it looks as if you might have a rather inductive load but a ciruit is needed. 500uF across the sensor terminals is rather more than I think you would need but it shouldn't blow up. Was it the right way round and rated for the applied voltage. If the scale on your plot is seconds then your unwanted spike is about 1mS long - ferrite beads aren't going to help and I think you may have too much inductance not too little.

     

    Michael Kellett

Reply
  • 0

    What is the sensor connected to ? From your scope trace it looks as if you might have a rather inductive load but a ciruit is needed. 500uF across the sensor terminals is rather more than I think you would need but it shouldn't blow up. Was it the right way round and rated for the applied voltage. If the scale on your plot is seconds then your unwanted spike is about 1mS long - ferrite beads aren't going to help and I think you may have too much inductance not too little.

     

    Michael Kellett

Children
No Data