Hello,
after reading this document "tinytile-Differences.pdf"
it seems there is a possibility to charge a battery "by moving
a zero-ohm resistor on the board". Which is the name of the resistor?
In the "TinyTILE_Schematic.pdf":
- the VIN_1 and VIN_2 are connected to GND, in this way the TI* BQ25101H is not powered.
- the setpoint current of charging is not set because the resistor R14 is not popolated.
This means that the Tinytile is not able to charge the battery.
Is there some info about this topic? Is there an other version of TinyTILE_Schematic?
Thanks,
Evgheni Munteanu