Actions
Forum Thread Details
  • Replies 4 replies
  • Subscribers 79 subscribers
  • Views 1089 views
  • Users 0 members are here
Related

Board to Board cable exender for RaspberryPi Camera V2

thanasispap

I want to make two raspberrypi cameras V2 come as close as they could for an optics setup for my experiments. I notice that the camera connector cable is attached on camera (cannot disconnect) but its second tail is attachable to the camera's board (easily disconnectable).

I want to extend the camera from the camera board for about 2.5cm.

Is there any cable extender or any other solution on the market?

 

I 've already found the pin type but unfortunately I cannot find the cable.

 

https://www.raspberrypi.org/forums/viewtopic.php?f=43&t=67465

 

image

Parents

  • Usually you need to pay very close attention to the cable length and spacing between the wires.

     

    One of the reasons the cable is short is due to the frequencies involved.

    If you lengthen the cable, you might change the transmission line effects and either get lots of noise or you could compromise the data integrity.

     

    I am curious as to why you need such close positioning.  You might find a simple 3D printed mirror arrangement might provide you better performance with less risk.

     

    DAB

Reply

  • Usually you need to pay very close attention to the cable length and spacing between the wires.

     

    One of the reasons the cable is short is due to the frequencies involved.

    If you lengthen the cable, you might change the transmission line effects and either get lots of noise or you could compromise the data integrity.

     

    I am curious as to why you need such close positioning.  You might find a simple 3D printed mirror arrangement might provide you better performance with less risk.

     

    DAB

Children
No Data