Does anyone here have any experience in using the FRDM-HB2001-EVM evaluation board with Freedom Board or the MC33HB2001 chip from NXP
It is an SPI programmable brushed DC motor driver which can work in 2 modes, H bridge and Half Bridge modes. This changing of mode can be done through the use of NXP's SPIGen software to program the FRDM-HB2001-EVM connected with FRSM-KL25Z. However, it seems that by using the software, the switching of modes is only temporary for as long as the SPIGen software runs.
Is there any way to make the MC33HB2001 chip permanently a Half-Bridge Driver on its own so that it does not have to be connected to the and the SPIGen software
Thanks a lot!