Programmer from PSOC4 Pinoneer Kit ?

Hello.

I can not find discussion on this theme.

May be anybody tryed or saw project:" How use PSOC4 Pioneer Kit in the programmer role for another devices "(if it's realy of course)?

I would not like to buy miniprog for 90USD!

Regards.

DAB over 12 years ago

Hi Arthur,

Are you wanting software to program the Psoc 4 board?
Or are you wanting software to program the basic Psoc chip?

The Psoc 4 board software is available on the Cypress web site.
You can contact them about doing basic chip burning.

Hope this helps,

DAB
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jesusantoniocar over 12 years ago

Hello Arthur.
Please read at:
http://www.cypress.com/?app=forum&id=4749&rID=79246.
See the table in section A.4 towards the end of the Pioneer Kit User Guide document - it documents what resistors you would need to short in order to use the onboard PSoC 5LP to program an external PSoC 4 (only PSoC 4 supported currently).
Warning - keep in mind to regain programming ability to the onboard PSoC 4 you will need to re-solder the shorted resistors.
the PSoC 5LP on the Pioneer Kit currently only supports programming a PSoC 4 device - onboard, or external.

Best regards,

Jesus Antonio.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Former Member over 12 years ago in reply to jesusantoniocar

It's that I need, it's great.
Thank you very much!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jesusantoniocar over 12 years ago in reply to Former Member

Hello Arthur.
Please read at:
http://www.element14.com/community/message/87864#87864/l/psoc-4-pioneer-kit-community-project085-uart-bootloader-in-psoc-4, Matt posted the PSoC 4 Pioneer Kit Community Project#085 – UART Bootloader in PSoC 4 , it can help you to program another psoc 4 devices using the psoc 5LP which is onboard in the pioneer kit.
Enjoy.

Jesus Antonio.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel