Have a question about Warp7? Ask it here!

Hi, I'm wondering what program the .brd files were produced in? Not Eagle by the looks of things..

Would be really useful if you could provide .dwg, .dxf or another generic CAD output for the board dimensions with component footprints.

I need to design a different IO/daughter board and prototype enclosure.

Thanks!

Ash

Hi Ash,

I've not checked, but if the gerber files are available they would be good for your need.

(As I understand the gerber files for this platform are published).

I use 'gerbv' for doing such measurements, basically once you've imported the layer you have the cursor

and co-ords or there is a measure tool.

Hi Shabaz,

I have only found .brd files but I can't open them with EAGLE or Altium, there's no info on what program was used. Standard gerber files have not been made available. Would it be possible to add them to the github repo?

Hi Ash,

You're right, I couldn't find the gerber files either, although some announcement on a different website had mentioned they would be available.

tusharp do you know where can the Gerber files be downloaded from? I'm guessing they should be available, since the PCB source CAD files are published.

Many thanks!

Hi Ash,

You're right, I couldn't find the gerber files either, although some announcement on a different website had mentioned they would be available.

tusharp do you know where can the Gerber files be downloaded from? I'm guessing they should be available, since the PCB source CAD files are published.

Many thanks!

Hi Shabaz /Ash

The *.brd design files of Warp-7 has been developed using Allegro software (not Eagle cadsoft) and it can be viewed using Allegro Free Physical Viewer 16.6

you can download the recent design files from below link:

Warp7 Revision2 PCB layout files

the snapshots of the same have been posted here

Regards

Bheema Rao

Hi Bheema,

Oh that's awesome, thanks for the link!