+ and GND show up in schematic, but not on board

Help,

Just designed my first circuit on EAGLE (Mac). The positive and GND symbols are showing up in the schematic, along with the connections, but when a board is created from the schematic, they are gone? Any ideas?

Thanks,

GWFAMI

Parents

Former Member over 12 years ago

I Think you did not connect the gnd and + with any pinhead or something. They are shown in schematic but as far as board is concerned it only show the connecting paths and components. You should try to coonect them with some pinhead or connector. Hope this will help you.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Former Member over 12 years ago

I Think you did not connect the gnd and + with any pinhead or something. They are shown in schematic but as far as board is concerned it only show the connecting paths and components. You should try to coonect them with some pinhead or connector. Hope this will help you.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data