Hi there,
Can anyone recommend a good (and cheap) board house that
accepts Eagle files?
Greets,
J. op den Brouw
I have used Myropcb since 3 years ago for 1, 2 & 4 layer, 1oz to 4 oz, 0.5
to 2.4mm , black & green soldermask, +++ .
Great job and nice price.
Very good service & quality.
And I have not royalty for this...
Thierry
"David Moodie" <dgmoodie@onetel.com.cut_this_off> skrev i melding
news:g7p0o9$bj9$1@cheetah.cadsoft.de...
J. op den Brouw wrote:
Hi there, Can anyone recommend a good (and cheap) board house thataccepts Eagle files? Greets, J. op den Brouw
If you are looking for 1 off then Olimex, as Joerg suggested are OK. I used to use them for 1 or 2 off parts, however I stopped due to the lack of milling options. I now tend to use myro, www.myropcb.com which typically works out at $100 for 4 off eurocard size boards. cheers David
If you are looking for 1 off then Olimex, as Joerg suggested are OK. I
used to use them for 1 or 2 off parts, however I stopped due to the lack
of milling options.
I now tend to use myro, www.myropcb.com which typically works out at $100
for 4 off eurocard size boards.
cheers
David
