Actions
Forum Thread Details
  • Replies 1 reply
  • Subscribers 161 subscribers
  • Views 174 views
  • Users 0 members are here
Related

Invalid wire width

blewis999

I am trying to auto route my board and I have encountered the message

"invalid wire width: 'VDD' (valid range is 0..13.107)" when I do auto

vdd gnd

 

Auto works ok without error

 

the class for power is set to 6 mil. i am using a PCie connector that

has .7mm smd pads; I have not encountered this before and there is

nothing I can find in the manual on this. Any help would be

appreciated.

 

 

  • Robert Lewis schrieb:

    I am trying to auto route my board and I have encountered the message

    "invalid wire width: 'VDD' (valid range is 0..13.107)" when I do auto

    vdd gnd

     

    Auto works ok without error

     

    the class for power is set to 6 mil. i am using a PCie connector that

    has .7mm smd pads; I have not encountered this before and there is

    nothing I can find in the manual on this. Any help would be

    appreciated.

     

     

    Check the current units of the grid setting and the value you

    defined for width. It must be within the limits 0..13.107 mm.

     

     

    --

    Mit freundlichen Gruessen / Best regards

    Richard Hammerl

    CadSoft Support -- hotline@cadsoft.de

    FAQ: http://www.cadsoft.de/faq.htm