I need advice for the following, I attached a 5 KB GIF drawing:
I want to place four pads on a board and connect one wire to each pad.
I want the four pads to be tied together on top and bottom layers with
either polygons or rectangles or something else.
I want the area on the finished board to appear as one big pad with four
through-holes in it. Bare copper with no mask over the area.
Each hole will have a wire attached and soldered in the final assembly and
all wires carry the same signal..
Should I use polygons or rectangles or something else to make this.
Thanks in advance for any help you can give me.