Question about DrillLegend

Hi, I moved couple of via , but the DrillLegend symbols were still at old location, how can I update DrillLegend table , also the DrillLegend symbols are not at center of via , is this normal ? Please help

Thanks

Vincent

Parents

0 Former Member over 12 years ago

On 2/7/2012 2:20 PM, Vincent Hoang wrote:
Hi, I moved couple of via , but the DrillLegend symbols were still at old location, how can I update DrillLegend table , also the DrillLegend symbols are not at center of via , is this normal ? Please help
Thanks
Vincent

The drillegend is a library part. I usually delete it before running the
ULP again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Former Member over 12 years ago in reply to Former Member

Hi Doug

I got it. Thank you very much
Do you have any idea about DrillLegend symbols off center ? Is it importance ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Former Member over 12 years ago in reply to Former Member

Hi Doug

I got it. Thank you very much
Do you have any idea about DrillLegend symbols off center ? Is it importance ?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Former Member over 12 years ago in reply to Former Member

Vincent Hoang wrote:
Hi Doug

I got it. Thank you very much
Do you have any idea about DrillLegend symbols off center ? Is it
importance ?

I have not observed them being 'off centre' with v5.
Maybe you are using v6. Changes are reqired to some ULPs to work correctly
with v6
Importance depends on the use of the output derived from the symbols.

Warren

--
Viewed / responded via the newsgroup at
news.cadsoft.de
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel