Trouble getting a board to route

Question

Hello, I am trying to route a very simple board, but I get airwires that will not automatically route. Any assistance would be appreciated.

Also, can anyone recommend a board maker in Australia?

Is there any way I can share my board schematic for assistance?

Best regards

Andrew

Former Member · Answer

On 8/9/2012 8:43 AM, Andrew Lindsay wrote:

Hello, I am trying to route a very simple board, but I get airwires that will not automatically route. Any assistance would be appreciated.

Also, can anyone recommend a board maker in Australia?

Is there any way I can share my board schematic for assistance?

Best regards

Andrew

One quick thing to try would be to set the routing grid to a smaller

value. Also check to make sure that you have configured the

auto-router to use all the layers so its not needlessly restricted.

Jim

Former Member · Answer

I can wholeheartedly recommend PCBFast in Seaford. I use them for all my

boards. A little dearer than Malaysia but streets ahead in quality.

Contact me to discuss. Cheers. Brian. mailto:Bd.taylor@bigpond.com

--

Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.