Manual routing from trace ends.

Question

Hi everyone, When routing traces which are longer than the airwire, is it possible to get Eagle to allow you to start at the end of the unfinished trace rather than the airwire hot point ? Thanks, Bob. 
 Attachments:

autodeskguest · Accepted Answer

Bob Beattie schrieb:

When routing traces which are longer than the airwire, is it possible to
get Eagle to allow you to start at the end of the unfinished trace
rather than the airwire hot point ?

You can start/continue routing from anywhere along an existing track

by using the CTL key.

Tilmann