Good Day everyone,
Is there a way for me to move/copy one part from one schematic to another using the eagle software?
Good Day everyone,
Is there a way for me to move/copy one part from one schematic to another using the eagle software?
Am 29.04.2014 18:23, schrieb Chevaughn Fraser:
Good Day everyone,
Is there a way for me to move/copy one part from one
schematic to another using the eagle software?
--
To view any images and attachments in this post, visit:
http://www.element14.com/community/message/110706
V6.x
Group the item/s to move
select move, do a right click on teh group
move over to the destination sheet.
HTH
Werner
On 04/30/2014 03:39 AM, Werner wrote:
Am 29.04.2014 18:23, schrieb Chevaughn Fraser:
Good Day everyone,
Is there a way for me to move/copy one part from
one
schematic to another using the eagle software?
--
To view any images and attachments in this post, visit:
http://www.element14.com/community/message/110706
V6.x
Group the item/s to move
select move, do a right click on teh group
move over to the destination sheet.
HTH
Werner
Werner's procedure will also work between different schematics. Group
the items in your source schematic, control-right-click and copy the
group. A copy of the group will float around with the mouse. Just hit
Escape to stop it. At this point the group is in your clipboard.
Without closing the control panel, close the schematic and board, and
open the target schematic. You should be able to paste the clip board.
HTH,
- Chuck