to: the forum
re: inconsistency errors -- fixed!
Fri 8/06/2010 12:58 pm
After fiddling around with a library part in eagle 5.10, I closed the
control panel without explicitly closing the schematic/board, which was
probably a mistake. When I started Eagle again, it had the dreaded
consistency errors! All four were of the "schematic has something, board
has no connection" flavor, and I could fix them by deleting the
connections on the schematic!
I've seen posts about consistency errors and how awful they are, so I
figured I'd contribute my mite.
======================================
j.g. owen * email: mailto:owen_bda4@yahoo.com
web: http://owenlabs.org
======================================
--
Web access to CadSoft support forums at www.eaglecentral.ca. Where the CadSoft EAGLE community meets.
