Does ver6 allow board to schematic yet?
If not, not sure I'll upgrade
On 21.12.2011 21:55, Dave Anderson wrote:
Does ver6 allow board to schematic yet?If not, not sure I'll upgrade
There are no changes concerning this. The board file does not
contain all the information that would be needed to create a
proper schematic. Most has to be done manually there.
What you already can do is
1) EXPORT Netlist and EXPORT Partlist
2) Creat schematic with same name (still empty)
3) Add parts according partlist and arrange them manually
4) RUN cmd-net-list2sch ... choose netlist...
5) Use SPLIT and MOVE to clean up all the nets in the schematic
6) Compare and adjust the part's values
Run ERC, check for inconsistencies
--
Mit freundlichen Gruessen / Best regards
Richard Hammerl
CadSoft Support -- hotline@cadsoft.de
FAQ: http://www.cadsoft.de/training/faq/
