Actions
Forum Thread Details
  • Replies 4 replies
  • Subscribers 189 subscribers
  • Views 466 views
  • Users 0 members are here
Related

Forcing it to use vias

StefanTh

Hi

 

I have a 4 layer board where layer 2 is GND and 15 Vcc, how do I force the router to use vias for GND and Vcc instead of using

top and bottom layer to connect devices ?

 

That is, I want the autorouter to use a via at the device pin instead of connecting

different GND/Vcc pins with each other via the the top and bottom layer

 

I tried tochange the layer cost etc. but it seems that it did not affect it

 

 

 

Regards Stefan

Parents

  • Stefan Olsson wrote on Thu, 25 October 2012 06:22

    I have a 4 layer board where layer 2 is GND and 15 Vcc, how do I force

    the router to use vias for GND and Vcc instead of using top and bottom

    layer to connect devices ?

     

    Route just the GND net with layer costs set high and via cost 0.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Reply

  • Stefan Olsson wrote on Thu, 25 October 2012 06:22

    I have a 4 layer board where layer 2 is GND and 15 Vcc, how do I force

    the router to use vias for GND and Vcc instead of using top and bottom

    layer to connect devices ?

     

    Route just the GND net with layer costs set high and via cost 0.

    --

    Web access to CadSoft support forums at www.eaglecentral.ca.  Where the CadSoft EAGLE community meets.

     

Children
  • in reply to e14 Contributor

    If I, on the tab "Route" in the Autorouter Setup, sets Layer cost to 40 for Top, Route2, Route15 and Bottom

    and the Via Costs to 0.

     

    It still use the Top layer copper to connect the GND pin of devices.

     

    Should I change the settings on the "Optiimize1 ... "Optimize4" as well (I copied the values from the Route Tab but it does not seems to affect the result) ?

     

    Also, I quite often get the result "Optimized ..... Polygons may have fallen apart", what does this mean ?